easyemployer workplace kiosk - troubleshooting

This article includes the following topics:

  • Troubleshooting the workplace kiosk

Troubleshooting your workplace kiosk

1. Familiarise yourself with your workplace kiosk unit

All In One Units

  • Power Plug: is cylindrical and often located on the far left of your all in one unit’s set of input and output connectors (while the unit’s screen is facing up). One end of the power pack cable supplied with the unit will plug into here with the other end plugged into a power point.
  • Network Cable port: is often located in the middle of your all in one unit’s set of input and output connectors. Careful! There are a number of ports that look similar however the network plug will always have two small status lights at the bottom.

2. Ensure the workplace kiosk unit is receiving power

  • Please go to your workplace kiosk unit and ensure the following cables are connected correctly:
    1. The power pack is plugged into an active power point
    2. Ensure the power cable is plugged into the back of your workplace screen (see power plug highlighted in step 1 above)
  • The unit should power on automatically once the power is correctly connected.  If the unit doesn’t power on use the on/off switch on the side of the screen. You can tell if the unit is powered on as the power indicator at the top of the screen will light up and the screen will show an image.
  • If the unit  does not power on please double check that the power cable is plugged in and make sure that the power point is active by plugging in another appliance / piece of equipment and ensuring it powers on correctly. If the other appliance / piece of equipment does not power on the powerpoint may be faulty and you will need to use another power point and/or seek assistance from an electrician

3. Ensure the workplace kiosk unit is properly connected to your computer network

  • Please go to your workplace kiosk unit and ensure the following cables are connected correctly:
    1. Ensure one end of the network cable is plugged into an active network port that has access to a persistent and stable internet connection.
    2. Ensure the other end of the network cable is plugged into the back of your workplace kiosk unit  (see network port highlighted in step 1 above)
  • Once this is done correctly a light should appear near the network cable plug on the back of the workplace kiosk unit

  • If no lights are shown near the network port after successfully powering on the unit, there is likely a problem with your network connection. Please double check that the network port you are using is active and that you are sure that the network cables you are using are not faulty. Please seek assistance from your IT support team and / or data cabler.
  • If after performing the above the time clock is showing that it is in offline mode, please ensure that the network port you plugged the network cable into is connected to a persistent and stable internet connection. Please contact your IT support team for more information.

If you have addressed all steps above and are still having problems after seeking help from your IT support team and/or electrician / data cables,  please contact our support team for further assistance.

 

Have more questions? Submit a request

Comments

Powered by Zendesk